Tom,
In looking over the two files Init3.c and Init3PlusMPG, I see that the command EnableAxis(0) is at the end of the axis setup data in the MPG file, but not the other file. This command is also there for axis 1 & 2.
Can you explain to me reason for the difference, please?
Thanks,
Michael Rosenfield
Group: DynoMotion
Message: 4503
From: Michael Rosenfield
Date: 4/6/2012
Subject: Re: init file question
Tom, OOPS! I just realized that the EnableAxis commands are in both files, but in different locations. I assume the EnableAxis wants to be after all the axis parameters are set?
